3-Meshup-200

3 in. Meshups Wiremesh Standoff - 200 pc

    94.22 94.22 94.22 USD

    94.22

    This combination does not exist.

    Add to Cart

    3 in. Meshups Wiremesh Standoff - 200 pc



    Height1.5 in.
    Slab Thickness4 in. to 6 in.
    Wire Gauge10, 8, 6, 4 , 0
    Schedule1 Mesh-up per 2 sqft.

    Put the Tubing and Mesh where you want it.

    Mesh-up, the new all plastic "chair," is flexible, elastic, easily and quickly attached to the mesh without ties. Above all it`s capable of returning the mesh approximately to its original position after being subjected to the loads commonly encountered while placing the mesh in the forms and spreading the concrete.


    Install 1 per 2 sqft - Ex. For 250sqft, order 1box (150pc) of Mesh-Ups
    (Designed to receive #6, #8, and #10 wire mesh)

    The flexible plastic support chair Mesh-up helps solve the problems of concrete slabs at grade will:
    1. Aid in getting the mesh off the ground.
    2. Help to support mesh above the membrane before and during pouring.
    3. Snap easily, quickly and firmly to mesh where the wires intersect; therefore, they do not rotate or fall off. See new design.
    4. Deflect when mesh is pressed down and then rebound; preventing wire bending over Mesh-up.
    5. Resist being pressed into subsurface because of large base ring. Use sand disk over soft fill.
    6. Reduce membrane puncture from sharp wire ends.
    7. Reduce supervision and require no "hook man."

    Plastic Springs

    Mesh-up SpringIt should be explained to the mechanics who place the chairs that Mesh-ups are plastic springs and when placed properly on mesh can produce excellent results with little effort. They are not magic and after deflection they must be allowed to rebound.

    Mesh-Ups are Easily Applied

    Mesh-ups are attached where wires intersect so they will not rotate or fall off. The lower slot in the Mesh-ups is to receive the lower wire at the intersection. This seems minor, but it should be pointed out so that units will be applied properly the first time. Use 4" high 4" x 4" blocks or larger, to elevate the wire to facilitate Mesh-up application.

    Wire Should Be Straight

    To position wire properly, it must be straight with no tendency to curl. If the wire is not adequately straightened, the inspector should be on the lookout for "low" spots where an additional Mesh-up might be necessary. And at "high" spots of little stress, a unit can be removed.

    Use Top Rebar

    In design where slabs are poured monolithicly with thickened beams, the mesh should be shown lying on top of the top reinforcing steel beam for additional support (any conduit and plumbing must be located under the wire).

    With a Few Precautions - A Better Job

    Tie wire at splice, tie wire to proper elevation at external forms, internal dividers, vertical projections ( plumbing, standpipe, vertical conduit, etc).

    Installation not recommended in subfreezing temperature

     
     
    Lotel Mesh-ups chairs

    This is a preview of the recently viewed products by the user.
    Once the user has seen at least one product this snippet will be visible.

    Recently viewed Products