|
 |
|
 |
ProMelt Mat, 3 ft. x 25 ft., 50W, 208V |
|
 |

Click to enlarge |
 |
208VAC Snow Melting Mats
ProMelt Mat, 3 ft. x 25 ft., 50W, 208V
Each mat holds dual heating elements on 3
inch centers on a reinforced tape grid. There’s
a grounded power lead on one end for a fast,
single-point electrical connection.
ProMelt Mat is a complete heating mat consisting of a series resistance heating cable and a single power lead for easy single-point connection. The heating cable is pre-formed into a mat to provide consistent spacing and quick roll-out installation on the jobsite. The heating mat length cannot be cut to fit.
Follow these recommendations when selecting
ProMelt Mats:
- Determine what voltage will be used:
120V, 208V, 240V, or 277V.
- Determine the heat output.
The climate and amount of snowfall will dictate this choice. In
general, most systems will require 50 Watts/Sq.Ft. to melt snow
and ice. Some residential or light commercial systems in temperate
climates, may need only 38 Watts/Sq.Ft. spacing.
- Determine the square footage of the area to be melted.
Do not include areas under built-ins like planters or similar
obstructions. Stay 3-6” from edges of slabs and do not cross
expansion joints if possible. Add up all the areas to be melted
and round down the nearest mat size(s) to fill the area. Either
2’-wide or 3’-wide mats can be selected.
More than one mat can be used to melt an area(s). Combine
mats in a manner not to exceed the capacity of the electrical
control selected. If using our ContactorPro controls, each area
should not exceed 50-amps, since these controls are built with
50-amp contactors. Therefore, we recommend dividing the area(s)
into “sub-zones”, if necessary or desired, to minimize the mat amp
load connected to each contactor.
Listing: ETL Listed for U.S. and Canada under UL 515, IEEE 515.1, and
CAN/CSA C22.2 No. 130-03
Listing file number: 3151992
For more information see:
|
Part Number: SM5020802536
|
|
|
|
|
|