Distribution Outdoor Reset Panel
Heat Exchanger with a Tekmar 361 reset control make it easy to separate a radiant system from a wood boiler or a glycol loop in a garage
or shop that requires isolation. Offers maximum outputs up to
150,00 BTU/Hr(150 M BH) based on nominal 180oF boiler temp, 130oF snowmelt
temp, and 30F delta tee. Actual output may be more or
less, depending on your project. The pumps and heat
exchanger are provided with service valves for easy access.
40" wide x 31.5" high x 12" deep
Standard equipment on each panel includes:
1-1/4" copper primary and secondary supply piping
Circulators on A and B side of heat exchanger, pre-wired and tested
Flat plate stainless steel heat exchanger with unions
Energy-saving 3 speed Watts Radiant circulators
Tekmar 361 Reset Control
High performance 1-1/4" micro-bubble air remover and expansion tank connection
(tank not included)
0-50 psi/60-320?F gauge
Isolation valves for easy servicing of circulators and easy air purging
O-ring sealed threaded unions
Cat 5 cable electrical connection for fast and easy connection to P or D Panels
9 ft 120V power cord
Powder coated steel enclosure
Controls
The pumps are pre-wired into the reset control. Inter-panel connection to other Hydronex panels is achieved
by plug and play Cat 5e cables, or are customizable for older applications.
