Primary Panel Selection Answer these questions to select the correct P Panel.
Q1. Do you have a glycol-filled system? Pick a PMan panel, with the manual fill option.
Q2. Do you want the convenience of an automatic fill feature? Select the PAuto panel with the built in Watts 9-11s M-3 Backflow Preventer/Boiler Fill Valve. Do not select the PAuto panel if you are using a glycol-filled system, as the glycol may be diluted, without your knowledge.
Q3. Do you want to connect an indirect domestic hot water heater to the boiler? Order a Primary panel (-RD) with DHW zone circulator.
P-Series panels are primary panels designed to supply
down-stream panels with boiler water, which will in turn
distribute boiler water to the radiant or other hydronic heating
zones. They also remove air and provide essential service and
monitoring capabilities. Plumbed in 1.25” L copper, these units
are also equipped with Watts quick-connect unions for quick
coupling to other HydroNex panels. All P Panels come pre-wired
with a 9’ power supply cord and measure 28” wide x 31.5” tall
x 12” deep (S).
Standard equipment includes:
• High performance micro-bubble air remover
• Primary loop pump of your choice
• Watts isolation pump flange
• Service valves
• 0-50psi/60-320F gauge
• White, powder-coated steel enclosure
The PAuto Panel is the same as the PMan Panel, but includes
the Watts 9-11S M3 backflow preventer/auto boiler fill valve.
This assembly also functions as a pressure-regulating, dual
check-valve backflow preventer with atmospheric vent. The panel
is plumbed in 1.25” L copper and equipped with Watts quickconnect
unions to quick coupling to other HydroNex panels.
Every P Panel comes with a pre-wired switching control. It
turns on the P Panel’s primary pump and closes a dry contact
for the boiler Aquastat upon a call for heat from any source. The
panel comes with a 9’ power supply cord for quick and easy field